HardTap Radar Detector HardWire Kit With In-line Fuse, DC Plug, 8' Long (Vehicle

Description

About the Hardwire HT-2096 Power Cord
This HardWire Kit for your Cobra, Uniden, K40, Radenso Whistler Radar Detector or BlackVue Dashcam is 8 feet in length and has an inline fuse so 12 Volt "ignition" power can be safely obtained from the nearest source. No more flat, shiny phone cord. Instead, a tight, protective sheathing with texture that looks factory, just like our MirrorTap Power Cords.  DIY'ers: Our installation instructions include the Step-by-Step VoltMeter process for determining the +12V Switch and Ground harness slots. Others: Visit your Dealer or local Car Audio Shop for installation.
What's Included
This BlendMount Kit includes everything needed for a professional looking installation:
8' Long Power cable w/DC connector and inline 2A fuse (replaceable)
(2) 5" Wire-ties
Installation instructions
Compatible Radar Detectors with DC Plug
Cobra:
RAD 500G, SPX 7800BT,  SPX 7700,  SPX 6700,  SPX 5500/5400/5300,  SRX 9700/9570/9470/9370,  iRAD 900/950,  RAD 450/350/250
Uniden:
LRD750,  DFR3,  DFR5,  DFR1
K40 Electronics:
RSL2, RD950
Radenso:
Pro M, Pro SE, Pro
Whistler:
CR68,  CR73,  CR88,  CR93,  CR95,  CR97,  Z-11R,  Z-15R,  Z19R, MFU440
Blackvue
: DR900S,  DR750S,  DR650S,  DR490
Instructions
Instruction Sheet
Click to Download
Voltmeter
How do you check voltage with a Voltmeter?
Guidelines on Using a Voltmeter to Locate Power and Ground
1. First set your voltmeter to the continuity setting (should beep when you touch the red and black probes together, telling you they are shorted).
2. Find a ground on the car somewhere, like a bolt under the dash, or a metal cross member.
3. Put the black probe on that ground, and touch the back of each exposed wire connector in the mirror harness with the red probe.
4. For each wire that beeps, that means that wire is grounded. Turn the ignition to the on position, then back to off, and make sure it beeps regardless of ignition position.
5. Put the voltmeter into VDC mode, to measure DC volts, turn the ignition to the on position.
6. Put the black probe on the ground wire found in #4.
7. Touch each of the wires in that harness with the red probe, and note which one(s) gives you +12-14 volts, turn the ignition off to verify that the volt readings go down to zero or close to zero.
8. That should define which two ports in that harness into which you would plug the MirrorTap, the black Prong into #4 above, and the Red to #7.
Disclaimer:
J28 DESIGN INC. will not be held responsible for any damage to, interference with, or malfunction of your vehicle's electrical system resulting from installation or use of the MTPC. Consult with your vehicle's dealer for any questions about your vehicle's electrical system. If you do not agree to these terms, do not use this product and return it for a full refund. If you are unable to use a voltmeter we recommend taking your vehicle to an auto stereo install shop.